Problem with snappyHexMesh
3 Attachment(s)
Hello to all,
I have a strange problem in the generation of the mesh with snappyHexMesh. When I created it, after the snap step, seems that some cells near the boundary are loss or not follows the boundary. I know that there are some thread about this problem but the solutions presented in their don't work. During the snap step appears this warming: FOAM Warning : Displacement (-4.016316e-07 1.993513e-06 5.287614e-08) at mesh point 14338 coord (0.009952381 0.04995016 -0.0009597589) points through the surrounding patch faces Smoothing displacement Displacement smoothed in = 8.69 s Moving mesh ... Is this warming related to the error? My geometry is very simple: a rectangular with a cylinder inside. I attach some pictures related to the error. Someone know what is the problem? Thanks to all for the willingness |
1 Attachment(s)
Hi giack,
I too faced the same problem. To solve it I increased my edge feature refinement level and max refinement in surfaceRefinement. Still the warning showed up. But this time I didn't get any error. :) I checked it with CheckMesh and it seems fine. When I very high refined blockMesh at start. and It didn't showed any warning at that time. Hence it must be related to refinement. I am attaching snaps of my mesh with FOAM warning |
if you solve problem, can you explain me ? I have same problem. I havent been solved this problem what ı do .
|
All times are GMT -4. The time now is 07:33. |