|March 7, 2014, 05:26||
Problem with snappyHexMesh
Join Date: Mar 2013
Posts: 94Rep Power: 5
Hello to all,
I have a strange problem in the generation of the mesh with snappyHexMesh. When I created it, after the snap step, seems that some cells near the boundary are loss or not follows the boundary. I know that there are some thread about this problem but the solutions presented in their don't work. During the snap step appears this warming:
FOAM Warning : Displacement (-4.016316e-07 1.993513e-06 5.287614e-08) at mesh point 14338 coord (0.009952381 0.04995016 -0.0009597589) points through the surrounding patch faces
Displacement smoothed in = 8.69 s
Moving mesh ...
Is this warming related to the error?
My geometry is very simple: a rectangular with a cylinder inside.
I attach some pictures related to the error.
Someone know what is the problem?
Thanks to all for the willingness
|March 11, 2014, 08:05||
Join Date: Feb 2014
Posts: 26Rep Power: 4
I too faced the same problem.
To solve it I increased my edge feature refinement level and max refinement in surfaceRefinement.
Still the warning showed up. But this time I didn't get any error.
I checked it with CheckMesh and it seems fine.
When I very high refined blockMesh at start. and It didn't showed any warning at that time.
Hence it must be related to refinement.
I am attaching snaps of my mesh with FOAM warning
|September 18, 2014, 10:03||
Join Date: Mar 2013
Posts: 8Rep Power: 5
if you solve problem, can you explain me ? I have same problem. I havent been solved this problem what ı do .
|snappyhexmesh, snappyhexmesh 3d|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Problem with snappyHexMesh: do not work||CjjJoy||OpenFOAM Native Meshers: snappyHexMesh and Others||8||February 8, 2014 02:13|
|Can I solve this problem by Fluent?||Kai_kc||FLUENT||1||October 27, 2010 05:29|
|stitchMesh and snappyHexMesh||gdbaldw||OpenFOAM||0||December 23, 2009 03:09|
|natural convection problem for a CHT problem||Se-Hee||CFX||2||June 10, 2007 06:29|
|Adiabatic and Rotating wall (Convection problem)||ParodDav||CFX||5||April 29, 2007 19:13|