|
MRF: imported mesh from ICEM not shown in ParaView and trying to merge with other
Dear All,
I am working with MRF on centrifugal compressors. First of all, I have just done MRF study (MRFsimpleFoam) with three rotor blades by creating MRF zones around the rotor blades. That method worked quite good. Now I would like to jump to centrifugal compressor. I already have a mesh which I have created in ICEM. I have imported Impeller mesh into opefoam from ICEM. It transfered fine but when I try to open using paraview, it could not load mesh. Can anyone help me with that please. Secondly, how can I merge imported mesh and the mesh that is generated by openfoam, which acts as a MRF zone? Many thanks, Ahmed |
| All times are GMT -4. The time now is 05:43. |