|
[Sponsors] |
[cfMesh] workflowControls options result in that Paraview cannot open |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 30, 2016, 20:15 |
workflowControls options result in that Paraview cannot open
|
#1 |
Member
Ron Burnett
Join Date: Feb 2013
Posts: 42
Rep Power: 13 |
After using any of the workflowControls options I'm left with files that
Paraview cannot open. What is required to make these readable? cfMesh ver 1.1.1, of 2.4 |
|
May 25, 2016, 05:31 |
|
#2 | |
Senior Member
|
Quote:
workflowControls stops the meshing process at some intermediate stage in the meshing workflow, writes the current status of the mesh on disk and exits. It seems the mesh was not saved correctly in this case. Do you maybe use binary/uncompressed? This combination sometimes causes problems. My recommendation is to use binary/compressed. I have never had any problems with it.
__________________
Principal Developer of cfMesh and CF-MESH+ www.cfmesh.com Social media: LinkedIn, Twitter, YouTube, Facebook, Pinterest, Instagram |
||
June 8, 2016, 08:22 |
|
#3 |
Member
Ron Burnett
Join Date: Feb 2013
Posts: 42
Rep Power: 13 |
Found MY error.......problem solved.
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[foam-extend.org] Problems installing foam-extend-4.0 on openSUSE 42.2 and Ubuntu 16.04 | ordinary | OpenFOAM Installation | 19 | September 3, 2019 18:13 |
[swak4Foam] groovyBC in openFOAM-2.0 for parabolic velocity bc | ofslcm | OpenFOAM Community Contributions | 25 | March 6, 2017 10:03 |
[swak4Foam] Swak4FOAM 0.2.3 / OF2.2.x installation error | FerdiFuchs | OpenFOAM Community Contributions | 27 | April 16, 2014 15:14 |
interFoam & decomposition method: scotch | MacGyver | OpenFOAM Running, Solving & CFD | 2 | May 23, 2012 07:00 |
paraFoam reader for OpenFOAM 1.6 | smart | OpenFOAM Installation | 13 | November 16, 2009 21:41 |