Making a mesh with different regions mesh size
Hi
Is anyone know how to make a mesh with different regions mesh size? for example http://www.cfd-online.com/OpenFOAM_D...your_image.gif http://www.cfd-online.com/OpenFOAM_D...your_image.gif Thank you mou |
Hi
Is anyone know how to ma
Hi
Is anyone know how to make a mesh with different regions mesh size? for example http://www.cfd-online.com/OpenFOAM_D...ges/1/8027.jpg http://www.cfd-online.com/OpenFOAM_D...ges/1/8028.jpg Thank you mou |
Hi Mou,
You can create the tw
Hi Mou,
You can create the two pieces separately, then merge them using mergeMesh. After the merging step, you can use stitchMesh to create a set of polyhedral cells at the interface between the two different parts. I hope this is helpful, Dragos |
Maybe this tutorial is helpful
|
Hi Dragos
Thank you so much
Hi Dragos
Thank you so much for your help. It was exactly what I need. mou |
Hi
The stitchMesh works for
Hi
The stitchMesh works for the two same face, without curve. because if we had two curved face with two different mesh size http://www.cfd-online.com/OpenFOAM_D...ges/1/8057.jpg the faces do not match each other http://www.cfd-online.com/OpenFOAM_D...ges/1/8058.jpg do you know how to stitch a curved faces? thank you mou |
Have you tried the stitchMesh
Have you tried the stitchMesh -partial?
|
I used also -partial, but it d
I used also -partial, but it does not work.
|
All times are GMT -4. The time now is 06:16. |