CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   OpenFOAM Meshing & Mesh Conversion (http://www.cfd-online.com/Forums/openfoam-meshing/)
-   -   List of Error codes (http://www.cfd-online.com/Forums/openfoam-meshing/61654-list-error-codes.html)

luiz eduardo February 11, 2004 11:14

Is there a list of error code
 
Is there a list of error codes and their meaning?
For instance, When I tryied to convert from gambit to foam, I got error code 6, but I dont know what it is.
Thanks,
Luiz

Mattijs Janssens (Mattijs) February 11, 2004 11:56

Foam does not print error cod
 
Foam does not print error codes, only error messages so I imagine your message comes from somewhere in the operating system.

Is it a 'bus error' (signal 6)? Do you get any other messages?

Do you get a core file? Does it show anything in the debugger? You have full sources for gambitToFoam in $FOAM_UTILILTIES/mesh/conversion, if you add

-g -O0 -DFULLDEBUG \

to Make/options and recompile ('wmake') and run in the debugger does it show something interesting?

Chris Greenshields (Chris) February 11, 2004 12:05

If the mesh file from gambit
 
If the mesh file from gambit is binary format you might expect the problem you describe. Try ascii.

luiz February 11, 2004 12:16

I got error code 6 in the jav
 
I got error code 6 in the java environment of FoamX.
Apparently my Gambit case was not correctly set. (it was missing boundary conditions at surfaces).
Thank you very much,
Luiz


All times are GMT -4. The time now is 00:48.