|
[Sponsors] |
December 30, 2009, 22:11 |
Gmsh Extrude Function
|
#1 |
Senior Member
|
I have successfully managed to use the Gmsh extrude function with a little help from the gui.
I am curious if there is a way to anticipate the numbering of the new faces that are created? This would allow the geometry to be written entirely with code, rather than having to use the gui to hunt down and label each face as its appropriate physical entity each time I make a small change. Thanks for the help! |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[mesh manipulation] refineMesh Error | mohsen.boojari | OpenFOAM Meshing & Mesh Conversion | 3 | March 1, 2018 22:07 |
channelFoam for a 3D pipe | AlmostSurelyRob | OpenFOAM | 3 | June 24, 2011 13:06 |
OpenFOAM static build on Cray XT5 | asaijo | OpenFOAM Installation | 9 | April 6, 2011 12:21 |
Version 15 on Mac OS X | gschaider | OpenFOAM Installation | 113 | December 2, 2009 10:23 |
Problem with compile the setParabolicInlet | ivanyao | OpenFOAM Running, Solving & CFD | 6 | September 5, 2008 20:50 |