CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   OpenFOAM Meshing & Mesh Conversion (http://www.cfd-online.com/Forums/openfoam-meshing/)
-   -   Half-hex mesh (http://www.cfd-online.com/Forums/openfoam-meshing/81687-half-hex-mesh.html)

Daniele111 November 3, 2010 19:31

Half-hex mesh
 
Hi
is possible create in OpenFoam a mesh composed of prisms created from hex cell divided in two part from the digonal plane?

McCarra November 18, 2010 15:00

Hello Daniele,

Yes, it is possible. In this case one face of the hexagon turns into an edge (two vertices). Despite the modification, the mesh is yet defined as an hexagon which eliminated vertices take the name of the corresponding edge vertices.

There's an example in page U-140 of the UserGuide

All the best


All times are GMT -4. The time now is 03:22.