CFD Online Discussion Forums - [snappyHexMesh] the problem in snapphexmesh axissymmetric geometric

CFD Online Discussion Forums (https://www.cfd-online.com/Forums/)

- OpenFOAM Meshing & Mesh Conversion (https://www.cfd-online.com/Forums/openfoam-meshing/)

- - [snappyHexMesh] the problem in snapphexmesh axissymmetric geometric (https://www.cfd-online.com/Forums/openfoam-meshing/97890-problem-snapphexmesh-axissymmetric-geometric.html)

the problem in snapphexmesh axissymmetric geometric

I use snappyHexMesh to refine a axisymmetric geometric. however, the snappy cannot work. the error is below

Code:

--> FOAM FATAL ERROR: 

cell 0 of level 0 does not seem to have 8 points of equal or lower level

cellPoints:6(0 1 7701 7702 151 152)

pointLevels:6{0}





    From function hexRef8::setRefinement(const labelList&, polyTopoChange&)

    in file polyTopoChange/polyTopoChange/hexRef8.C at line 3527.



FOAM aborting

I think the cell in axis patch have only six point. as a result, the snappyHexMesh can refine the cell. Anybody can me some suggestion for this problem?

Hi

I have same problem also, any solutions yet ?

CFD_user