CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   OpenFOAM Meshing & Mesh Conversion (http://www.cfd-online.com/Forums/openfoam-meshing/)
-   -   Refine Region of Hex Mesh using Tet or polyhedra? (http://www.cfd-online.com/Forums/openfoam-meshing/98694-refine-region-hex-mesh-using-tet-polyhedra.html)

ic3wall March 16, 2012 10:03

Refine Region of Hex Mesh using Tet or polyhedra?
 
Hi all,

I have a nice mesh made purely of hexahedra, I would like to be able to select a region and refine it using tetrahedra or polyhedra ? So far, in OF mesh utilities, I have only seen tools to split hexes 2x2x2 ...

Is that possible, if so how ?

Look at the picture in post #11 in this thread, it would look something like that but I would like to be able to select the area where I want tetrahedra of polyhedra..


All times are GMT -4. The time now is 03:06.