|October 26, 2013, 14:11||
Post-processing a LES simulation
Join Date: Oct 2013
Posts: 7Rep Power: 5
thank you very much for your help. Soon i am going to try this at work and for sure i will tell you how it did.
By now i had to face an other problem while using paraview. The simulation results i am managing within paraview are results of a Large Eddy Simulation. Therefore there is a huge amount of "particles". Unfortunately they are shown as small cubes and the fluid looks very angular especially in cam curves.
Is there a way to interpolate between the edges of the cubes - maybe some antialiasing so the fluid looks more curvy and smooth.?
|October 26, 2013, 14:20||
Join Date: Mar 2009
Location: Lisbon, Portugal
Blog Entries: 39Rep Power: 103
I've moved your post from the other thread - Paraview slice type - cylinder? - as it does not ask about the same topic.
If I understand you correctly, the problem is that you're seeing Cell Data and not Point Data. I wrote something about this sometime ago... here you go: studying a valve case - post #12
|Thread||Thread Starter||Forum||Replies||Last Post|
|Ansys Post processing||ano999||ANSYS||1||May 27, 2011 16:24|
|NO model vs post processing in coal combustion,CFX||sakalido||CFX||1||April 15, 2011 14:07|
|Question about post processing||qtian||OpenFOAM Post-Processing||0||July 24, 2007 12:44|
|LES post processing||moun||FLUENT||0||April 23, 2005 10:30|
|post processing in CFD||MANISH BHARGAVA||Main CFD Forum||0||October 17, 1998 20:51|