|October 19, 2008, 10:14||
Dear all, I want to set the
I want to set the dimension in Gmsh instead of using "transformPoints -scale '(1E-6 1E-6 1E-6)'" after gmshTofoam, I use "Mesh.ScalingFactor = 1e-06;"
I could see that the nodes data are fine, but I could not see the geometry in paraFoam.
When I disable this "Mesh.ScalingFactor = 1e-06;", I could see the geometry quite well.
Therefore, I would like to post a simple case here. This attached you could see the geometry, then when you disable the comment "Mesh.ScalingFactor = 1e-06;" in .geo file, you will have the problem.
If you know it, please let me know, thank you.
|Thread||Thread Starter||Forum||Replies||Last Post|
|gmsh||jojo||Main CFD Forum||5||August 31, 2009 23:11|
|GMSH and OpenFOAM||derath||OpenFOAM Mesh Utilities||44||September 4, 2008 05:09|
|ChannelOodles with gmsh||lofty||Open Source Meshers: Gmsh, Netgen, CGNS, ...||7||April 16, 2008 16:44|
|Gmsh with physicals||Rasmus Gjesing (Gjesing)||Open Source Meshers: Gmsh, Netgen, CGNS, ...||9||February 2, 2006 15:36|
|GMSH Meshes||rbw||OpenFOAM Pre-Processing||5||September 26, 2005 04:20|