[General] Problem to display mesh in Paraview

Voyage_gui · August 9, 2011, 10:16

Hi everyone,

thanks in advance for any kinds of help.

Here's my small pb: when i want to visualize my mesh using Paraview, it links automatically in triangular mode the vertices (2D) whereas i would prefer staggered grid.

It s ok on the border of the domain (see picture) but not if i create a slice inside the domain. I can't find the appropriate option. The mesh is cartesian and uniform.

Guillaume

Voyage_gui · August 16, 2011, 05:40

No answer for my message in the bottle ?

Thanks

dasch · August 16, 2011, 10:21

Hi

try to use the filter 'extract cells by region' instead of 'slice' to create your slice.

Daniela

Voyage_gui · August 16, 2011, 10:49

Hi Daniela,

This could be alsmot awesome if i could extract only the plane i chose instead of half a volume (check the pict). I tried to create it directly from a slice but it didn't work out. If you have any idea ...

Thanks a lot in advance

ertan · August 18, 2011, 16:30

In addition to what Daniela suggested, on the 'extract cell by region' panel, select both 'extract on intersected' and 'extract intersected'.

HTH

Voyage_gui · August 19, 2011, 04:03

Great, thanks a lot Ertan ! I chose last time one of those 2 options independently from the other one without success!

Thanks Daniela too

Guillaume

August 16, 2011, 10:21		#3
dasch New Member Daniela Join Date: Apr 2010 Posts: 7 Rep Power: 16	Hi try to use the filter 'extract cells by region' instead of 'slice' to create your slice. Daniela Haces likes this.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Mesh is doing some problem	prwl120	FLUENT	2	May 21, 2015 14:05
[ICEM] Problem with using the Delaunay volume mesh method	manahara	ANSYS Meshing & Geometry	12	December 25, 2014 21:54
[ICEM] problem in mesh output	mehrzad	ANSYS Meshing & Geometry	2	December 10, 2014 18:07
[Gmsh] 2D Mesh Generation Tutorial for GMSH	aeroslacker	OpenFOAM Meshing & Mesh Conversion	12	January 19, 2012 03:52
Icemcfd 11: Loss of mesh from surface mesh option?	Joe	CFX	2	March 26, 2007 18:10

August 16, 2011, 05:40		#2
Voyage_gui Member Join Date: Sep 2010 Posts: 30 Rep Power: 15	No answer for my message in the bottle ? Thanks

August 18, 2011, 16:30		#5
ertan New Member Ertan Karaismail Join Date: Apr 2009 Posts: 17 Rep Power: 17	In addition to what Daniela suggested, on the 'extract cell by region' panel, select both 'extract on intersected' and 'extract intersected'. HTH

August 19, 2011, 04:03		#6
Voyage_gui Member Join Date: Sep 2010 Posts: 30 Rep Power: 15	Great, thanks a lot Ertan ! I chose last time one of those 2 options independently from the other one without success! Thanks Daniela too Guillaume