CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   OpenFOAM Paraview & paraFoam (http://www.cfd-online.com/Forums/openfoam-paraview/)
-   -   View cyclic boundaries using MRFSimpleFoam (http://www.cfd-online.com/Forums/openfoam-paraview/61196-view-cyclic-boundaries-using-mrfsimplefoam.html)

gabriel July 27, 2007 08:42

Hi when I run a MRFSimpleFoa
 
Hi
when I run a MRFSimpleFoam case with cyclic boundary conditions (rotational periodicity), I can not plot the patches of the cyclic boundaries in paraview. They are empty. If I change the boundary conditions to e.g. wall or i include them into the MRFZones then I can see them. It don't care if I can see them or not in paraview, the only thing is, i get insecure if the boundaries are adapted correct.

Has somebody there had the same experience?

mfg Gabriel


All times are GMT -4. The time now is 11:16.