CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   OpenFOAM Paraview & paraFoam (http://www.cfd-online.com/Forums/openfoam-paraview/)
-   -   Mesh (http://www.cfd-online.com/Forums/openfoam-paraview/61235-mesh.html)

shuo September 29, 2006 01:06

Hi is there a way of displa
 
Hi

is there a way of displaying the boundary patches of the meshed geometry in Paraview so that you know which physical boundaries you are modifying?

Shuo

dmoroian September 29, 2006 02:46

A similar topic was posted jus
 
A similar topic was posted just few days ago:
Displaying solid boundaries

It says: use Filters->ExtractParts

gschaider September 29, 2006 02:52

- "Extract Parts" in the "Filt
 
- "Extract Parts" in the "Filter"-menu is what you're thinking of.
- Or you're using the "region"-Subpane of the "Parameters"-tab of the data
- Propably there is at least a third way to do it in paraview that I don't know about

shuo September 29, 2006 18:34

Hi Thanks for the response.
 
Hi

Thanks for the response. What I meant to say is there a way of displaying the names of the boundary conditions on the mesh like in Fluent. With a complex mesh it is hard to know exactly where the boundary conditions are being applied
Regards
SHuo


All times are GMT -4. The time now is 00:33.