CFD Online Discussion Forums

CFD Online Discussion Forums (
-   OpenFOAM Paraview & paraFoam (
-   -   Visualizing face normals in ParaView (

nikunj April 18, 2006 01:30

Hi guys, I am using a hand-cod
Hi guys, I am using a hand-coded translator for porting in a tetrahedral mesh into an OpenFOAM polyMesh. I ran checkMesh and its reporting problems with incorrectly oriented face normals and I was wondering if there is away of visualizaing the face normals in ParaView (based on the order in which the vertices are listed for a face)?

All times are GMT -4. The time now is 23:42.