 |
 |
 |
|
|
|
[Sponsors] | ||||
September 14, 2009, 03:14
|
problem of mesh of paraview
|
#1 |
|
Member
Heintz Simon
Join Date: Sep 2009
Location: Germany
Posts: 36
Rep Power: 16    |
Hello,
I generate a mesh with StarCCM+ and I convert this mesh with ccm26ToFoam. But when i see the mesh of ParaView, it's not the same mesh (some cells are cut but I have the same number of cell with openfoam and starccm+, look at the picture of http://img11.imageshack.us/img11/2034/netzvergleich.jpg). Is there a problem for the presentation in paraView ? Must I check a option in this software ? I thank you Best regards Simon Heintz |
|
|
|
|
|
September 14, 2009, 11:27
|
|
#2 |
|
Senior Member
Niels Nielsen
Join Date: Mar 2009
Location: NJ - Denmark
Posts: 555
Rep Power: 27 |
Hi
The std openfoam reader module for paraview do not display polys correctly. use foamToVTK and open paraview and load the generated .vtk file which will be in a folder under your case called VTK. Best regards |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 09:38 |
| [OpenFOAM] snappyHexMesh - can't open mesh in ParaView | tfigueiro | ParaView | 0 | June 11, 2015 19:05 |
| Mesh is doing some problem | prwl120 | FLUENT | 2 | May 21, 2015 14:05 |
| [ICEM] problem in mesh output | mehrzad | ANSYS Meshing & Geometry | 2 | December 10, 2014 18:07 |
| Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 06:20 |
Linear Mode
