paraFoam problem

openfoam_user · November 20, 2009, 02:13

Hi Bruno,

thanks for your great help ! The thread that you have mentioned gave me the answer.

Just remove ~/.config/ParaView and the problem disappears !!!

Now paraFoam and paraView (with foamToVtk) work well again with version 3.6.1.

Regards,

Stephane.

wyldckat · November 20, 2009, 06:08

Wow... I didn't see that before! I'm glad you saw that, because I didn't!

That's another one for the books...

Best Regards,
Bruno

dinesh2n@gmail.com · July 8, 2010, 02:20

Thank you ...
same problem of scale I too facing in paraview i.e. correct for vectors and for scalers it is 0 to 1. Removing ~/.config/ParaView worked for me too....

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
UDF compiling problem	Wouter	Fluent UDF and Scheme Programming	6	June 6, 2012 04:43
Incoherent problem table in hollow-fiber spinning	Gianni	FLUENT	0	April 5, 2008 10:33
natural convection problem for a CHT problem	Se-Hee	CFX	2	June 10, 2007 06:29
Adiabatic and Rotating wall (Convection problem)	ParodDav	CFX	5	April 29, 2007 19:13
Is this problem well posed?	Thomas P. Abraham	Main CFD Forum	5	September 8, 1999 14:52

November 20, 2009, 02:13		#21
openfoam_user Senior Member stephane sanchi Join Date: Mar 2009 Posts: 287 Rep Power: 7	Hi Bruno, thanks for your great help ! The thread that you have mentioned gave me the answer. Just remove ~/.config/ParaView and the problem disappears !!! Now paraFoam and paraView (with foamToVtk) work well again with version 3.6.1. Regards, Stephane.

November 20, 2009, 06:08		#22
wyldckat Super Moderator Bruno Santos Join Date: Mar 2009 Location: Lisbon, Portugal Posts: 4,278 Blog Entries: 31 Rep Power: 45	Wow... I didn't see that before! I'm glad you saw that, because I didn't! That's another one for the books... Best Regards, Bruno

July 8, 2010, 02:20		#23
dinesh2n@gmail.com Member Dinesh Nath Goswami Join Date: Dec 2009 Location: Kanpur, India Posts: 40 Rep Power: 5	Thank you ... same problem of scale I too facing in paraview i.e. correct for vectors and for scalers it is 0 to 1. Removing ~/.config/ParaView worked for me too....