 |
 |
 |
|
|
|
[Sponsors] | ||||
May 7, 2016, 13:48
|
No output produced
|
#1 |
|
Member
Justin Maris L. Natividad
Join Date: Mar 2016
Posts: 38
Rep Power: 10  |
Good day. I copied the tutorial on motorbike and I used my model to test it. upon running allrun, everything seems fine. After the run, I tried to use reconstructPar to see the results in each timestep, but an error occurs. Also, in the folder, there is no postProcessing folder, and upon opening paraview, there is no results for p and U. How can I fix this problem? Thank you for the consideration
|
|
|
|
|
|
May 7, 2016, 17:49
|
Error?
|
#2 |
|
New Member
Maryam
Join Date: Dec 2015
Posts: 13
Rep Power: 10 |
What is the error message?
|
|
|
|
|
|
|
May 8, 2016, 11:17
|
|
#3 |
|
Member
Justin Maris L. Natividad
Join Date: Mar 2016
Posts: 38
Rep Power: 10 |
I checked the log.simplefoam it says that there is an error in the patch field. Anyways I checked the snappyHexMeshdict and found out that the patch field name is different for the patch in the variable p U etc. I corrected it and it worked. But still thank you
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [swak4Foam] outputTime in Swak function | immortality | OpenFOAM Community Contributions | 20 | October 6, 2022 12:08 |
| No *.plt or *.vtk output files produced | Vartan | SU2 Installation | 8 | October 18, 2016 02:25 |
| writing execFlowFunctionObjects | immortality | OpenFOAM Post-Processing | 30 | September 15, 2013 06:16 |
| RNG diverged during the analysis the flow over a multi element airfoil, why? | s.m | OpenFOAM Running, Solving & CFD | 0 | August 5, 2013 08:39 |
| mixerVesselAMI2D's mass is not balancing | sharonyue | OpenFOAM Running, Solving & CFD | 6 | June 10, 2013 09:34 |
Linear Mode
