 |
 |
 |
|
|
|
[Sponsors] | ||||
September 30, 2010, 09:21
|
Integrate variables over surface
|
#1 |
|
Member
Join Date: Dec 2009
Posts: 33
Rep Power: 16  |
So I can't use patchAverage since my patch is internal.
I then tried the integrate variables filter over my internal patch by using the slice filter. However, my results didn't seem right. Am I doing something wrong? smillion |
|
|
|
|
|
September 30, 2010, 09:27
|
|
#2 |
|
Member
Join Date: Dec 2009
Posts: 33
Rep Power: 16 |
Also how does the user know whether the integrated velocity is Ux, Uy or Uz?
I'm trying to find the area-averaged Uy. |
|
|
|
|
|
|
January 20, 2016, 11:56
|
|
#3 |
|
Senior Member
Thomas Oliveira
Join Date: Apr 2015
Posts: 114
Rep Power: 12 |
I had a similar problem (integrate a variable over an internal plane) and managed to do so. Please refer to this post and see if it helps: http://www.cfd-online.com/Forums/ope...tml#post581774
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [swak4Foam] How to define boundary condition variables by using previosly defined variables? | pawlo | OpenFOAM Community Contributions | 8 | September 13, 2020 11:37 |
| [snappyHexMesh] Surface triangulation using snappyHexMesh | shaileshbg | OpenFOAM Meshing & Mesh Conversion | 4 | October 17, 2019 04:42 |
| Automatic micro for calculating surface average values for different variables | mkh_sakr | FLUENT | 0 | May 1, 2018 00:26 |
| [Gmsh] boundaries with gmshToFoam | ouafa | OpenFOAM Meshing & Mesh Conversion | 7 | May 21, 2010 12:43 |
| [OpenFOAM] 'integrate variables' filter on a polyhedral mesh gives wrong results... | jbf | ParaView | 0 | September 4, 2009 04:08 |
Linear Mode
