[Nucleophobe]

I've performed a simulation using simpleFoam and would now like to create an animation of the steady-state results by moving a slice through the geometry.

Is there a way to automate this? I know that I could save a screenshot and then move the slice coordinates but that is a bit tedious.

The result will be something like this:
http://www.youtube.com/watch?v=YFsmsi8uLAs

Thanks,
-Ken

[gschaider]

Originally Posted by Nucleophobe

I've performed a simulation using simpleFoam and would now like to create an animation of the steady-state results by moving a slice through the geometry.

Is there a way to automate this? I know that I could save a screenshot and then move the slice coordinates but that is a bit tedious.

The result will be something like this:
http://www.youtube.com/watch?v=YFsmsi8uLAs

Thanks,
-Ken

Paraview allows you to "animate" filter properties (which is probably what you want): Have a look at this
http://www.itk.org/Wiki/ParaView/Users_Guide/Animation

[Nucleophobe]

Originally Posted by gschaider

Paraview allows you to "animate" filter properties (which is probably what you want): Have a look at this
http://www.itk.org/Wiki/ParaView/Users_Guide/Animation

Thanks, I believe that is what I was looking for.