CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   OpenFOAM Post-Processing (http://www.cfd-online.com/Forums/openfoam-post-processing/)
-   -   ParaFoam Cyclic Boundaries (http://www.cfd-online.com/Forums/openfoam-post-processing/108024-parafoam-cyclic-boundaries.html)

Atoom October 12, 2012 07:54

ParaFoam Cyclic Boundaries
 
Hi Everyone,

I just startet using OpenFoam for a 2-D case and it works pretty well. For the postprocessing I am using Paraview (parafoam) which also works good - unless I am setting up cycling boundary conditions. I already searched this Forum and found people with identical problems, but no solution which worked for me. The only hint I got is that the order of the boundaries is wrong - but what is the correct order? I tried to use createPatch but this did not work for me as well.

The mesh is generated in Gmsh and is basicly a square with two ripples at the bottom.

Thank you for your help!


All times are GMT -4. The time now is 23:26.