|October 23, 2012, 14:57||
problem with paraview 'stream tracer with custom source'
Join Date: Jul 2011
Posts: 56Rep Power: 5
I was trying to plot streamlines in paraview for my openfoam cases. What I did is to import the inlet and internalmesh separately, apply 'mask point' on the inlet, and use filter 'stream tracer with custom source', with mask point as source and internalmesh as the input. At some point, I got a satisfactory streamline plot, everything looks nice. However, I could not duplicate the plot. I went back and did everything the same, the resultant streamlines became extremely short, only 1/10 of length of the flow pathway. And tuning the parameters didn't give me better results either.
Anyone has any idea on why this happens or how to make a streamline in paraview correctly?
I truly appreciate your help.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Problem in using paraview||meballav||ParaView||11||October 12, 2012 16:03|
|GPU Linear Solvers for OpenFOAM||gocarts||OpenFOAM Announcements from Other Sources||35||March 1, 2012 21:41|
|"parabolicVelocity" in OpenFoam 2.1.0 ?||sawyer86||OpenFOAM Running, Solving & CFD||21||February 7, 2012 12:44|
|ParaView installation problem on Suse 11.4||victorz||OpenFOAM Installation||4||February 6, 2012 18:26|
|UDFs for Scalar Eqn - Fluid/Solid HT||Greg Perkins||FLUENT||0||October 11, 2000 03:43|