|May 15, 2013, 15:07||
forces calculation on wigley case
Join Date: May 2013
Posts: 1Rep Power: 0
I am doing simulations on a boat for an internship university and I arrived at the point of having calcolarmi forces.
I read about all threads by adding the relevant command lines in controlDict but the results I get are unacceptable: too small and above all never go to convergence. the flow has a speed of 3m / s.
how can I fix? command lines I add are these:
COFR (0 0 0)
the name of the patches is that correct? if not, where can I see that right?
the library to which you refer is correct for OpenFOAM 2.2.0 (this is the version I use)?
please help me. I have a sense of urgency!
|Thread||Thread Starter||Forum||Replies||Last Post|
|[OpenFOAM] Forces Calculation||m_f||OpenFOAM Post-Processing||6||January 13, 2015 04:27|
|Forces on wall in unsteady case||sondinho||FLUENT||4||December 8, 2012 08:55|
|forces in interFoam||Svensson||OpenFOAM Post-Processing||2||May 9, 2012 13:31|
|i need a case file for erosion calculation||Mysara Mohyaldinn||FLUENT||0||September 24, 2008 22:32|
|Wigley hull test case||giovanni ieria||Main CFD Forum||0||November 22, 1999 12:30|