CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   OpenFOAM Post-Processing (http://www.cfd-online.com/Forums/openfoam-post-processing/)
-   -   Temperature and streamlines simultaneously in paraview for wedge-typed mesh (http://www.cfd-online.com/Forums/openfoam-post-processing/125340-temperature-streamlines-simultaneously-paraview-wedge-typed-mesh.html)

babakflame October 23, 2013 11:09

Temperature and streamlines simultaneously in paraview for wedge-typed mesh
 
2 Attachment(s)
Greetings All

I want to get a picture from paraview which has both temperature contour and streamlines. After clicking on stream tracer from filter in paraview, I need to specify points for line source; I do not know how to determine these points for a wedge-typed mesh. would some body plz hint me?
My system of coordinates are completely clear from the attachments; If you tell me where the point should be, I would become very happy.

X domain: 0 - 0.15
y domain: 0 - 0.9
z domain: -0.0065429081 - 0.0065429081

Regards
Bobi

babakflame October 23, 2013 13:22

1 Attachment(s)
Greetings all

I found the point source positions: (according to geometry)

(0 0.45 0) to (0.15 0.45 0)
The result is the following image; however I want a continous temp slice on which streamlines are shown in black lines. would somebody plz hint me how can I get it?

Any hint?

Regards
Bobi


All times are GMT -4. The time now is 19:07.