Velocity fields and probes do not match up

nskelly · October 31, 2019, 03:52

Hi,

I ran some LES simulations of turbulent flow over a backward facing step. I was aiming to calculate turbulence parameters, velocity fluctuations, turbulent kinetic energy and turbulence intensity through time. To do so I put a number of probes in the computational domain to obtain velocity through time at various points of interest.

However, when I compare the velocity obtained by the probe to the fields that are saved in my timestep folders, the velocity values are different. Therefore, the results in different TKE and turbulence intensity.

Would anyone why this would be? Is it part of some sort of interpolation of the values from where the probes are located?

Thanks in advance

KTG · November 1, 2019, 13:07

You should post an example of what you mean and the function object you ran. Interpolation is an option that you would have specified in the function object.

October 31, 2019, 03:52	Velocity fields and probes do not match up	#1
nskelly Member Nat K Join Date: Oct 2017 Posts: 68 Rep Power: 8	Hi, I ran some LES simulations of turbulent flow over a backward facing step. I was aiming to calculate turbulence parameters, velocity fluctuations, turbulent kinetic energy and turbulence intensity through time. To do so I put a number of probes in the computational domain to obtain velocity through time at various points of interest. However, when I compare the velocity obtained by the probe to the fields that are saved in my timestep folders, the velocity values are different. Therefore, the results in different TKE and turbulence intensity. Would anyone why this would be? Is it part of some sort of interpolation of the values from where the probes are located? Thanks in advance

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Error in Reading Velocity at each time step while using TimeVarryingMappedFixedValue	faiazk	OpenFOAM Running, Solving & CFD	3	October 1, 2018 15:04
[OpenFOAM] Probes function gives different values than ParaView	Bazinga	ParaView	4	November 29, 2017 13:59
How many probes can I have in a simulation ?	guilha	OpenFOAM Post-Processing	13	September 17, 2016 07:26
probes function not working in Openfoam 2.1.1	nandiganavishal	OpenFOAM	7	July 26, 2012 11:06
Resolving Velocity Magnitudes with Probes	steph79	OpenFOAM	2	August 9, 2010 18:16

November 1, 2019, 13:07		#2
KTG Senior Member Abe Join Date: May 2016 Posts: 119 Rep Power: 9	You should post an example of what you mean and the function object you ran. Interpolation is an option that you would have specified in the function object.