|January 29, 2015, 11:43||
problem to calculate yplus in moving mesh
Join Date: Apr 2012
Posts: 13Rep Power: 6
I am currently running moving Cylinder with pimpleDyMFoam. I runned it in serial (one core) and then I could get the amount of yPlus in each time step.
But the problem is that when I run the tutorial in parallel and I want to calculate yplus the following error appeared on the terminal.
--> FOAM FATAL ERROR:
Face zone name frontOutZone for GGI patch frontOut not found. Please check your GGI interface definition.
From function label ggiPolyPatch::zoneIndex() const
in file meshes/polyMesh/polyPatches/constraint/ggi/ggiPolyPatch.C at line 675.
Aborted (core dumped)
Could any body help me in this problem?
Many thanks for the attention
|Thread||Thread Starter||Forum||Replies||Last Post|
|snappyhexmesh remove blockmesh geometry||philipp1||OpenFOAM Running, Solving & CFD||2||December 12, 2014 11:58|
|Add Mesh Layers doesnt work on the whole surface||Kryo||OpenFOAM Native Meshers: snappyHexMesh and Others||8||September 13, 2012 09:28|
|How to set up a dynamic mesh for a piston moving through a tube of variable diameter?||karkar||OpenFOAM Meshing & Mesh Conversion||0||July 4, 2012 06:54|
|2D Mesh Generation Tutorial for GMSH||aeroslacker||Open Source Meshers: Gmsh, Netgen, CGNS, ...||12||January 19, 2012 04:52|
|moving Mesh problem||ulisses||OpenFOAM||1||September 3, 2010 19:30|