CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > OpenFOAM Post-Processing

Valdation of a tunnel blockage using simpleFoam????

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Display Modes
Old   July 9, 2015, 02:08
Default Valdation of a tunnel blockage using simpleFoam????
  #1
Senior Member
 
tareqkh's Avatar
 
Khamlaj
Join Date: Nov 2010
Location: United States
Posts: 124
Rep Power: 6
tareqkh is on a distinguished road
Hello Foamers,

I hope that you are all fine. I have been following a project about the implementations of an actuator disk model using simpleFoam around a propeller. I have successfully done all the validations except plotting the velocity distribution for different (R_tun/R_rot). As you can see in the following attachment the validations have been done in different velocities (7, 10, 14 m/s). I only need to do the validation when the velocity 10 m/s, which is the case that has been done by Mikkelsen. I am a little bit confused on how these plots have been done. I have done plot over line of the velocity in the simpleFoam, and it was between either U magnitude or (Ux, Uy, or Uz) with respect to the distance from downstream of the propeller to the point in which the velocity gets stabilized. How can I plot figure 6.5 in the attached document named "validation 1" as well as figure 14 in the file named "validation"? I do not know how this plot is being done. I would really appreciate your clarifications. I am also attaching the result file.

Thanks in advance,

http://www.mediafire.com/download/lq...idation.tar.gz

Mikkelsen.csv.tar.gz
tareqkh is offline   Reply With Quote

Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Valdation of a tunnel blockage using simpleFoam???? tareqkh OpenFOAM Verification & Validation 0 July 9, 2015 01:56
simpleFoam parallel solver & Fluent polyhedral mesh Zlatko OpenFOAM Running, Solving & CFD 3 September 26, 2014 06:53
Wake blockage effect in a wind tunnel Nick R Main CFD Forum 1 September 3, 2014 16:39
interFoam vs. simpleFoam channel flow comparison DanM OpenFOAM Running, Solving & CFD 11 January 5, 2013 07:21
Wind Tunnel Blockage question ohma0043 CFX 4 February 13, 2011 10:12


All times are GMT -4. The time now is 03:25.