|
[Sponsors] |
Non-zero wall velocity using foamToTecplot360 |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 11, 2010, 18:45 |
Non-zero wall velocity using foamToTecplot360
|
#1 |
New Member
elbert
Join Date: Mar 2009
Location: USA
Posts: 10
Rep Power: 17 |
Dear Foamers,
When I use foamToTecplot360 and post-process in Tecplot I observe wall velocities to be non-zero. The boundaryMesh plt file has it right. Does the volume data plt contain data one cell away from wall or is it missing a ghost cell? Kindly let me know. Thanks, Elbert |
|
December 14, 2010, 16:24 |
|
#2 |
Member
Maryam Mousazadeh
Join Date: Oct 2010
Posts: 47
Rep Power: 15 |
hi Elbert.
I hope to your problem was resolved. excuse me,I have an intermediat quistion.I don't know how I can convert foam data to tecplot360?which utility should I use? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Velocity fluctuation distribution near a wall | Matthieu | FLUENT | 1 | June 3, 2021 09:40 |
the air velocity is not zero on the wall? | Li Rong | CFX | 5 | April 9, 2018 02:02 |
A girl fail to plot velocity profile when mesh changes + Wall function | asherah | STAR-CCM+ | 0 | February 19, 2010 17:45 |
display velocity at wall | Flo | FLUENT | 1 | October 22, 2007 09:24 |
wall velocity not zero | drew | CFX | 2 | July 20, 2007 15:24 |