|
[Sponsors] |
[General] Rendering Lines on Surface of Slice after using Surface With Edges |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
January 31, 2021, 15:32 |
Rendering Lines on Surface of Slice after using Surface With Edges
|
#1 |
Member
Chris
Join Date: Dec 2018
Posts: 36
Rep Power: 7 |
Hello All,
I'm looking for tips on how to get rid of these horizontal lines that show up on my slice in Paraview. The attached picture is from "Surface" representation after I used the "Surface with Edges" representation. I know the horizontal lines are a rendering issue since they weren't on the "Surface" before I looked at the "Surface with Edges" representation and they move if I zoom in or out. For clarity I don't mean the large gray regions, they are from slicing through a solid body, but the horizontal lines that show up in the fluid region (which is red and blue). Usually I remake the slice when this happens but it didn't work this time. I will probably just start a new paraview file to get a clean "Surface" since I am in a bind, but I am open to ideas to not have to deal with this anymore. Thanks, Chris |
|
January 31, 2021, 15:55 |
|
#2 |
Member
Chris
Join Date: Dec 2018
Posts: 36
Rep Power: 7 |
In the process of setting up my new file I had the same issue. Turns out it was related to my custom viewpoint that I used to quickly jump to the same view.
Would be nice to correct the view rather than make it again, but correcting a view is easier than setting up a new file. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Gmsh] gmshToFoam generates patches with 0 faces and 0 points | Simurgh | OpenFOAM Meshing & Mesh Conversion | 4 | August 25, 2023 07:58 |
[snappyHexMesh] SnappyHexMesh running killed! | Mark JIN | OpenFOAM Meshing & Mesh Conversion | 7 | June 14, 2022 01:37 |
OpenFOAM error | Vinay Kumar V | Main CFD Forum | 0 | February 20, 2020 09:17 |
Area weighted average over slice of surface | spelletier | FLUENT | 0 | June 13, 2019 22:53 |
[ICEM] Automatic mesh generation script surface intersection problem | stuart23 | ANSYS Meshing & Geometry | 0 | May 13, 2011 01:10 |