|December 1, 2012, 12:58||
Boundary Contitions/Mass fraction
Join Date: Dec 2012
Posts: 65Rep Power: 4
can someone help me please?
I had to simulate a combustion in a simple tube (diameter 25mm and length 500mm). Propane Air is used for the combustion.
I used a transient (0.2s time steps 0.002s) solution and a Eddy Disserpation Model and activated Eddy disserpation coefficient B=0.5
I think the problem is either in my boundary conditions or in the mass fraction.
But maybe sth else is wrong cause i never get a combustion
Boundary Conditions I tried were:
-Inlet at one end of the tube and the rest as a wall (free slip wall)
-Outlet at one end and the rest as a wall (the "in" wall is a hot free slip wall)
-Everything a wall (the "in" wall is a hot free slip wall)
My mass fractions are:
|Thread||Thread Starter||Forum||Replies||Last Post|
|An error has occurred in cfx5solve:||volo87||CFX||5||June 14, 2013 17:44|
|Water subcooled boiling||Attesz||CFX||7||January 5, 2013 04:32|
|On the damBreak4phaseFine cases||paean||OpenFOAM Running, Solving & CFD||0||November 14, 2008 22:14|
|Multicomponent fluid||Andrea||CFX||2||October 11, 2004 05:12|
|Boundary conditions?||Tom||Main CFD Forum||0||November 5, 2002 02:54|