|March 22, 2013, 12:06||
Join Date: May 2009
Posts: 15Rep Power: 8
How can I divide a patch into two separate patches relative to a STL file? For example, in the attached picture, I want to divide the cylindrical patch into two patches: one for the faces inside the red STL surface, and another for the other faces.
I tried using a series of setSet commands, and I can get the cells associated to each patch, but how can I extract the outer faces of the cell sets? Any alternative method?
|Thread||Thread Starter||Forum||Replies||Last Post|
|Case running in serial, but Parallel run gives error||atmcfd||OpenFOAM Running, Solving & CFD||10||November 24, 2013 07:35|
|fluentMeshToFoam||preibie||OpenFOAM||24||October 8, 2012 14:57|
|About the createPatchDict||flotran||OpenFOAM||1||December 9, 2011 08:52|
|About the createPatchDict||flotran||Main CFD Forum||0||December 7, 2011 12:31|
|radiation patches, viewfactors||beams||CD-adapco||1||March 12, 2009 08:39|