|
[Sponsors] |
August 14, 2013, 03:27 |
Problem with mesh
|
#1 |
New Member
Pepe Perez
Join Date: Aug 2013
Posts: 7
Rep Power: 12 |
Hello, i'm trying to mesh a wing, and a model body-wong in 3D with blockMesh, but after dealing and struggling with it i'm getting quite upset. I can't get "OK" with checkMesh, since always got orthogonality and aspect ratio problems. i shouldn't decrease grading too much cause i need low y+
Could anybody help me out with both meshes? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Dynamic Mesh Problem. | Tom Clark | FLUENT | 10 | June 21, 2021 04:27 |
[ICEM] ICEM Structured Mesh Problem | OMJT | ANSYS Meshing & Geometry | 3 | March 22, 2013 10:06 |
[GAMBIT] SOFC crossflow mesh possible problem??? | epc1 | ANSYS Meshing & Geometry | 1 | February 4, 2013 01:57 |
Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 18:10 |
Convergence problem when ustructured mesh is used. | SangJin Ryu | Siemens | 3 | October 5, 2000 20:26 |