 |
 |
 |
|
|
|
[Sponsors] | ||||
August 14, 2013, 03:27
|
Problem with mesh
|
#1 |
|
New Member
Pepe Perez
Join Date: Aug 2013
Posts: 7
Rep Power: 12  |
Hello, i'm trying to mesh a wing, and a model body-wong in 3D with blockMesh, but after dealing and struggling with it i'm getting quite upset. I can't get "OK" with checkMesh, since always got orthogonality and aspect ratio problems. i shouldn't decrease grading too much cause i need low y+
Could anybody help me out with both meshes? 
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Dynamic Mesh Problem. | Tom Clark | FLUENT | 10 | June 21, 2021 04:27 |
| [ICEM] ICEM Structured Mesh Problem | OMJT | ANSYS Meshing & Geometry | 3 | March 22, 2013 10:06 |
| [GAMBIT] SOFC crossflow mesh possible problem??? | epc1 | ANSYS Meshing & Geometry | 1 | February 4, 2013 01:57 |
| Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 18:10 |
| Convergence problem when ustructured mesh is used. | SangJin Ryu | Siemens | 3 | October 5, 2000 20:26 |
Linear Mode
