Home > Forums > Software User Forums > OpenFOAM > OpenFOAM Pre-Processing

Calculating Eddy Viscosity in order to visualize at Post-Processing.

Mark Forums Read

Reply

Search this Thread

September 4, 2013, 14:43	Calculating Eddy Viscosity in order to visualize at Post-Processing.	#1
RTom New Member Tom Join Date: Jun 2013 Posts: 26 Rep Power: 12	Hi, I am working on a series of simulations with compressible flow, using rhoPimpleFoam. I already run the simulation but I can't find how to plot the Turbulent Viscosity or Eddy Viscosity (mut) on OpenFOAM at the Post-Processing. What should I do for plotting the "mut" property? Is there any code or utilities for the visualizing of the turbulent viscosity after the solving? Thanks to all!

Reply

Tags

eddy viscosity, turbulent viscosity

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Plotting the Viscosity Contour in CFD Post	ashtonJ	FLUENT	3	June 2, 2015 12:06
[OpenFOAM] is parallel processing available in parafoam for post processing?	sachinlb	ParaView	1	August 14, 2012 09:52
How to visualize/ calculate applied heat source during post processing	lavoz	CFX	2	June 1, 2012 04:35
Post Processing in FEM	Abhijit Tilak	Main CFD Forum	0	April 26, 2004 11:59
post processing in CFD	MANISH BHARGAVA	Main CFD Forum	0	October 17, 1998 20:51

All times are GMT -4. The time now is 21:10.