can slip boundary condition in openFoam mean "inviscid wall" ?

s.m · October 9, 2013, 10:55

Hi
I am simulating the flow over an multi element airfoil, i have studied in a research that for simulating the correct experiment conditions "we should reat the wind-tunnel walls as inviscid walls"
now my question is that, how can i define the "inviscid wall" in openFoam?
if we set slip boundary condition for the top and bottom side of our domain,can this boundary condition in openFoam mean "inviscid walls" ?

i mesh a squre domain around my sirfol, i put the freestream for the inlet and outlet patch (left and right side), i don't know what boundary condition should i use for topAndBottom side!

please guide me

Thank you very much

saeed115 · October 10, 2013, 15:29

hi dear S.m.....as i know about boundary condition in openfoam for an airfoil you could use slip condition for top and bottom of your domain.GOOD LUCK
here is a training for how to simulate flow around an airfoil in open foam
http://www.google.com/url?sa=t&rct=j...53899372,d.Yms

s.m · October 11, 2013, 13:27

Quote:

Originally Posted by saeed115

hi dear S.m.....as i know about boundary condition in openfoam for an airfoil you could use slip condition for top and bottom of your domain.GOOD LUCK
here is a training for how to simulate flow around an airfoil in open foam
http://www.google.com/url?sa=t&rct=j...53899372,d.Yms

Thank you, but my question is that, how can we chose inviscid wall for topAndBottom ?

October 9, 2013, 10:55	can slip boundary condition in openFoam mean "inviscid wall" ?	#1
s.m Senior Member saeideh mohamadi Join Date: Aug 2012 Posts: 229 Rep Power: 14	Hi I am simulating the flow over an multi element airfoil, i have studied in a research that for simulating the correct experiment conditions "we should reat the wind-tunnel walls as inviscid walls" now my question is that, how can i define the "inviscid wall" in openFoam? if we set slip boundary condition for the top and bottom side of our domain,can this boundary condition in openFoam mean "inviscid walls" ? i mesh a squre domain around my sirfol, i put the freestream for the inlet and outlet patch (left and right side), i don't know what boundary condition should i use for topAndBottom side! please guide me Thank you very much

October 10, 2013, 15:29		#2
saeed115 New Member saeed Join Date: Feb 2013 Posts: 19 Rep Power: 13	hi dear S.m.....as i know about boundary condition in openfoam for an airfoil you could use slip condition for top and bottom of your domain.GOOD LUCK here is a training for how to simulate flow around an airfoil in open foam http://www.google.com/url?sa=t&rct=j...53899372,d.Yms s.m likes this.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
SLIP BOUNDARY CONDITION	vas	FLUENT	12	June 27, 2019 05:48
k-epsilon boundary condition in openFoam	bhattach	OpenFOAM	8	January 17, 2014 04:50
No-slip condition for non-resolved boundary layer in open channel banks	Lupocci	Main CFD Forum	1	January 17, 2013 03:11
Axis Boundary condition in OpenFoam	hayhari	OpenFOAM Running, Solving & CFD	0	September 20, 2012 05:32
No Slip / 0 shear Boundary Condition	evan	FLUENT	0	July 29, 2004 13:37