CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   OpenFOAM Pre-Processing (http://www.cfd-online.com/Forums/openfoam-pre-processing/)
-   -   Change boundary type at certain level of pressure reached inside domain (http://www.cfd-online.com/Forums/openfoam-pre-processing/125089-change-boundary-type-certain-level-pressure-reached-inside-domain.html)

anmartin October 18, 2013 10:00

Change boundary type at certain level of pressure reached inside domain
 
1 Attachment(s)
I would like to simulate the fluid passing through a mechanical fuse, I need to break (open the membrane) between two domains at specific pressure (membrane broke).


It is possible with OF?
it is possible with swak4foam?

Best regards.

Attachment 26183

nimasam October 20, 2013 02:17

1- its possible with OpenFOAM (code stream)
2- its possible with swak4Foam (groovyBC in this third party is preferred)


All times are GMT -4. The time now is 12:04.