 |
 |
 |
|
|
|
[Sponsors] | ||||
November 14, 2013, 15:59
|
Tolerance x Residual Control
|
#1 |
|
New Member
Marcelo
Join Date: May 2013
Posts: 10
Rep Power: 12  |
Hi all,
I am not understanding what is the difference between "tolerance" and "residual control" in the SIMPLE solver. Could you help me to understand? Thank you very much for the help, Best regards, Marcelo Lopes |
|
|
|
|
|
July 2, 2015, 10:03
|
|
#2 |
|
New Member
Chris Coutinho
Join Date: Jan 2015
Location: Netherlands
Posts: 28
Rep Power: 11 |
I have the exact same question, and I'm curious if anyone has a good answer. The OpenFOAM user guide does not even mention residualControls; however, there are some users who say here that this is the convergence criteria.
I'm quite confused. I will report back with either personal experience or a more conclusive answer. Cheers, C |
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Unstabil Simulation with chtMultiRegionFoam | mbay101 | OpenFOAM Running, Solving & CFD | 13 | December 28, 2013 13:12 |
| Micro Scale Pore, icoFoam | gooya_kabir | OpenFOAM Running, Solving & CFD | 2 | November 2, 2013 13:58 |
| pimpleFoam: turbulence->correct(); is not executed when using residualControl | hfs | OpenFOAM Running, Solving & CFD | 3 | October 29, 2013 08:35 |
| calculation stops after few time steps | sivakumar | OpenFOAM Running, Solving & CFD | 7 | March 17, 2013 06:37 |
| Orifice Plate with a fully developed flow - Problems with convergence | jonmec | OpenFOAM Running, Solving & CFD | 3 | July 28, 2011 05:24 |
Linear Mode
