CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   OpenFOAM Pre-Processing (http://www.cfd-online.com/Forums/openfoam-pre-processing/)
-   -   Boundary condition on imported solid. (http://www.cfd-online.com/Forums/openfoam-pre-processing/126921-boundary-condition-imported-solid.html)

Mariusz November 29, 2013 01:13

Boundary condition on imported solid.
 
1 Attachment(s)
Hi,

Could someone help me with the following question.

I'd like to consider flow domain as shown in attachment: This is a 3D case, where inside a box (represented on a drawing by a large rectangle) there is a cylinder (represented on a drawing by small rectangle). This cylinder is generated using blender and saved for example as stl file. Geometry would be meshed using snappyHexMesh.

The question is:

Is it possible to define a boundary condition (velocity inlet) on a face of imported stl solid?

Best regards,
Mariusz.

nimasam November 30, 2013 08:04

you can define a patch for stl file, so you can assign what BC you like


All times are GMT -4. The time now is 09:52.