|
[Sponsors] |
December 27, 2013, 01:20 |
heat source with fvOptions
|
#1 |
New Member
eric
Join Date: Dec 2013
Posts: 1
Rep Power: 0 |
Hi everybody,
I'm running the cavity case in the tutorials/compressible/ras directory. I would like to create a heat source in the fluid region. For example to create a heat source in the center of the domain: heatSource { type scalarSemiImplicitSource; active true; selectionMode points; points ( (0.05 0.05 0) ); scalarSemiImplicitSourceCoeffs { volumeMode specific; injectionRateSuSp { h (10 0); } } } There are other options instead of using the variable enthalpy, h? can I use temperature directly? as if I have a surface at a constant temperature where the fluid flows around? Thanks! |
|
November 6, 2014, 02:00 |
|
#2 |
Member
Nicole Andrew
Join Date: Sep 2014
Location: Pretoria, South Africa
Posts: 58
Rep Power: 11 |
Hi Eric,
Did you ever figure out how to implement a heat source with fvOptions? Regards, Nicole |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[swak4Foam] groovyBC in openFOAM-2.0 for parabolic velocity bc | ofslcm | OpenFOAM Community Contributions | 25 | March 6, 2017 10:03 |
[swak4Foam] Error bulding swak4Foam | sfigato | OpenFOAM Community Contributions | 18 | August 22, 2013 12:41 |
Heat source Inetsity (W/m3)-Moving | Sami.Sawalha | ANSYS | 0 | February 17, 2013 02:35 |
[swak4Foam] funkySetFields compilation error | tayo | OpenFOAM Community Contributions | 39 | December 3, 2012 05:18 |
UDFs for Scalar Eqn - Fluid/Solid HT | Greg Perkins | FLUENT | 0 | October 11, 2000 03:43 |