|
[Sponsors] |
March 19, 2014, 01:09 |
Problem with decomposePar
|
#1 |
New Member
Sreetej
Join Date: Feb 2014
Location: Singapore
Posts: 14
Rep Power: 12 |
Greetings All
I am running a vortex simulation in simple rectangular geometry, though the mesh elements are in large number. I have used funkysetfields command to initiate a vortex and then when I wish to use parallel simulation using decomposePar, I got this error message Time = 0 fileName::stripInvalid() called for invalid fileName U~ For debug level (= 2) > 1 this is considered fatal Aborted This was when the start time in my controlDict file was 0. But strangely when I changed the start time to 1 or 10, anything other than 0, decomposePar works without the error. Could anybody please explain. Thanks in Advance... |
|
March 19, 2014, 02:17 |
|
#2 |
Senior Member
Bernhard
Join Date: Sep 2009
Location: Delft
Posts: 790
Rep Power: 21 |
Did you even read the error message? U~ is (apparently), an invalid filename. I bet that you have a file 0~ in the ./0 folder, but not in ./1 or ./10.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
UDF compiling problem | Wouter | Fluent UDF and Scheme Programming | 6 | June 6, 2012 04:43 |
Problem in implementing cht | tilek | CFX | 3 | May 8, 2011 08:39 |
natural convection problem for a CHT problem | Se-Hee | CFX | 2 | June 10, 2007 06:29 |
Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 19:13 |
Is this problem well posed? | Thomas P. Abraham | Main CFD Forum | 5 | September 8, 1999 14:52 |