|
[Sponsors] |
appropriate boundary conditions for ventilation? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
December 25, 2014, 02:37 |
appropriate boundary conditions for ventilation?
|
#1 |
Member
a
Join Date: Nov 2013
Posts: 34
Rep Power: 12 |
hi
this is my geometry: half of a room with a duct for ventilation and a window (pressure outlet). as I searched, buoyantSimpleFoam is a good solver for this purpose. but I dont know the appropriate boundary conditions for: alphat epsilon k mut p_rgh where and how can I find the way to assign these values? thanks |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
GETVAR Error in Multiband Monte Carlo Radiation Simulation with Directional Source | silvan | CFX | 3 | June 16, 2014 09:49 |
Question about heat transfer coefficient setting for CFX | Anna Tian | CFX | 1 | June 16, 2013 06:28 |
[Netgen] boundary conditions and mesh exporting | vaina74 | OpenFOAM Meshing & Mesh Conversion | 2 | May 27, 2010 09:38 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |