 |
 |
 |
|
|
|
[Sponsors] | ||||
How do I have to calculate Epsilon in a k-epsilon turbulent model. |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 5, 2016, 05:45
|
How do I have to calculate Epsilon in a k-epsilon turbulent model.
|
#1 |
|
New Member
miguelangel
Join Date: Jul 2015
Posts: 2
Rep Power: 0  |
Hi,
I have to use this kind of turbulence model, but I have doubts in the way to inizialitze epsilon. I use this formula: eps= 0.09 * ką'⁵ / L; where L is the lenght of the turbulence, I've supposed that is the diameter of my study problem, an injector nozzle. When I do this, it figures a number, but when I run the simulation the results are 4 orders of magnitud higher. This is my problem. Thank you 
|
|
|
|
|
|
May 6, 2016, 08:11
|
|
#2 |
|
Senior Member
Joachim Herb
Join Date: Sep 2010
Posts: 650
Rep Power: 21 |
Are you looking for these?
http://www.cfd-online.com/Wiki/Turbu...ary_conditions http://www.cfd-online.com/Tools/turbulence.php |
|
|
|
|
|
|
| Tags |
| cfd, k-epsilon |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Error in Two phase (condensation) modeling | adilsyyed | CFX | 15 | June 24, 2015 19:42 |
| A question about a turbulent model in multiphase flows | amin.z | FLUENT | 0 | March 22, 2015 14:32 |
| Standard k-epsilon based Nonequilibrium turbulent viscosity model | nikesh | OpenFOAM Programming & Development | 1 | February 13, 2013 02:53 |
| Jump in epsilon values near the wall : low re k-epsilon model | malaboss | OpenFOAM Verification & Validation | 1 | February 1, 2013 16:36 |
| Calculation of Epsilon in LES model | Yuri Almeida | OpenFOAM | 2 | January 18, 2013 07:43 |
1Likes
Linear Mode
