 |
 |
 |
|
|
|
[Sponsors] | ||||
February 12, 2009, 03:17
|
I have been learning OpenFoam
|
#1 |
|
New Member
Johanna Airaksinen
Join Date: Mar 2009
Posts: 5
Rep Power: 6  |
I have been learning OpenFoam for only few months and I don't know very much and one problem I'm facing right now is that I'd like to initialize a case with Fluent data. There were some messages I found about this subject, but it still left me a little confused about how difficult it would be.
I'm using the 1.5 version of OpenFoam. |
|
|
|
|
|
February 12, 2009, 03:36
|
what type of messege u found?
|
#2 |
|
Guest
Posts: n/a
|
what type of messege u found?
|
|
|
|
||
|
February 12, 2009, 04:08
|
There was this message "Fluent
|
#3 |
|
New Member
Johanna Airaksinen
Join Date: Mar 2009
Posts: 5
Rep Power: 6 |
There was this message "Fluent to Foam" in May 2008. Where someone asked about this...
And then in very old discussion from 2006 "Convert exisiting data to openfoam", there is a mention about possible "fluentDataToFoam" utility. |
|
|
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Error while initializing a case | summer | FLUENT | 0 | April 15, 2008 16:22 |
| fluent case n data files not exporting to tecplot | krishna | FLUENT | 2 | February 17, 2007 23:24 |
| problem opening case and data in fluent | Adam | FLUENT | 1 | February 15, 2007 16:53 |
| import Fluent data&case to ANSYS | Vlad S | FLUENT | 0 | April 2, 2003 04:49 |
| Initializing using existing data | Ray | FLUENT | 2 | September 16, 2002 16:14 |
Linear Mode
