Home > Forums > OpenFOAM Pre-Processing

Calculix help

Mark Forums Read

Reply

July 9, 2008, 01:37	Dear all, I am new in C	#1
ivanwhlau Member Ivan Lau Join Date: Mar 2009 Location: Hong Kong Posts: 56 Rep Power: 6	Dear all, I am new in CFD. I have tried several mesh converter and I like Calculix. cavityTest1.fbd However, I made a simple 2D cavity model using Calculix. I run both the tutorial's cavity models using icoFoam and turbFoam. icoFoam: results are similar. turbFoam: results are very different. Did I make any mistake on my fbd model? I also checeked mesh using paraFoam and also checkMesh. The meshes are fine. Please advise if possible. Thanks, Ivan

Reply

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Dealing with stl files from Calculix in Netgen	psosnows	Open Source Meshers: Gmsh, Netgen, CGNS, ...	7	July 11, 2011 11:17
Some perhaps stupid questions about calculix	lynx	Open Source Meshers: Gmsh, Netgen, CGNS, ...	11	May 17, 2010 06:48
Blender Calculix he8 polyMesh	gdbaldw	OpenFOAM Meshing & Mesh Conversion	3	October 2, 2008 11:33
CalculiX can write now a ployMesh	klaus	Open Source Meshers: Gmsh, Netgen, CGNS, ...	6	December 12, 2007 05:02

All times are GMT -4. The time now is 23:42.