|May 16, 2008, 05:06||
Hi Forum, Just a few weeks
Join Date: Mar 2009
Posts: 13Rep Power: 8
Just a few weeks ago i asked if somebody has experiences with CuBit as a preprocessor in
combination with OpenFoam. I only got one answer.
I was told that there should be no problem importing CuBit-meshes into OpenFoam.
Is there somebody else who has experiences with CuBit and importing itīs meshes into OpenFoam.
I would be very pleased get some information about this.
Thanks a lot
|Thread||Thread Starter||Forum||Replies||Last Post|
|CuBit||t42||OpenFOAM Meshing & Mesh Conversion||6||July 10, 2008 07:51|