Home > Forums > Software User Forums > OpenFOAM > OpenFOAM Pre-Processing

Wallshearstress simplefoam

Mark Forums Read

Reply

Search this Thread

December 14, 2007, 04:18	hi everybody i would like t	#1
rengu Guest Posts: n/a	hi everybody i would like to display wallshearstress for my case with turbulent incompressible fluid with the solver simplefoam i have had a look on this topics http://www.cfd-online.com/cgi-bin/Op...cus/discus.cgi but i find it a bit complicated for a new user of OpenFOAM like me is there a more simple way to obtain wallshear stress for this kind of solver? best regards

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problems with the RSM in simpleFoam	sberg	OpenFOAM Running, Solving & CFD	10	February 25, 2014 19:39
What is phi in simpleFoam	ehsan_vaghefi	OpenFOAM Running, Solving & CFD	7	September 29, 2013 11:00
WallShearStress	sunnysun	OpenFOAM Post-Processing	0	October 30, 2008 05:15
SimpleFoam error	sven82	OpenFOAM Running, Solving & CFD	0	October 16, 2008 04:13
WallShearStress Utility a little doubt	sek	OpenFOAM Running, Solving & CFD	3	March 7, 2008 08:31

All times are GMT -4. The time now is 05:04.