 |
 |
 |
|
|
|
[Sponsors] | ||||
May 22, 2006, 13:34
|
Hey everybody,
I am stuck o
|
#1 |
|
New Member
Ram Poudel
Join Date: Mar 2009
Location: Flagstaff, arizona, USA
Posts: 9
Rep Power: 6  |
Hey everybody,
I am stuck on how to generate grid readable to OpenFOAM from from my GIS based DEM (digital elevation model) data. It consist of XYZ point file (1000 x 1000 points). Here my objective is to Analyse the flow over a terrain usning RANS or LES. Any suggestion will be highly appriciated, Regards |
|
|
|
|
|
May 22, 2006, 13:41
|
Generate a 999x999 grid with t
|
#2 |
|
Super Moderator
Mattijs Janssens
Join Date: Mar 2009
Posts: 1,416
Rep Power: 13 |
Generate a 999x999 grid with the correct upper boundary. Find out what the point numbering is for the lowest layer of points.
Hack the movePoints application to move the points to the correct position while morphing the internal points. |
|
|
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Using Femap to Generate grid for Openfoam | jdkummer | OpenFOAM Meshing & Mesh Conversion | 8 | July 26, 2010 22:47 |
| how to generate data at nodes? | Meenu | FLUENT | 0 | June 9, 2008 12:20 |
| How to generate this grid??? | leoyee | FLUENT | 2 | July 9, 2004 14:26 |
| How to generate BFC grid? | zczhang | Phoenics | 2 | December 17, 2002 09:00 |
| How to generate the grid for a 3d object? | ben | Phoenics | 3 | March 20, 2002 16:30 |
Linear Mode
