I have a 2D wedge to represent
I have a 2D wedge to represent a rotating lid driven flow. I have been using only 1 cell along the thikness, as suggested in the documentation. I would like to know if it is correct to increase the number of the cells in the thickness.
Thanks |
I got an error when I tried...
I got an error when I tried... So I assume the answer is no...
|
Thanks.
I have reduced the
Thanks.
I have reduced the angle of the wedge from 5º to 1.5º as I refined the mesh in both x,y directions to assure convergence. Is this procedure correct? |
All times are GMT -4. The time now is 12:45. |