CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   OpenFOAM Pre-Processing (http://www.cfd-online.com/Forums/openfoam-pre-processing/)
-   -   Doubt regarding 3-D meshing of a rocket nose (http://www.cfd-online.com/Forums/openfoam-pre-processing/74585-doubt-regarding-3-d-meshing-rocket-nose.html)

nakul April 3, 2010 15:54

Doubt regarding 3-D meshing of a rocket nose
 
Hi,
I am new to using openFoam and hav recently set up a 3-d case. Its a simple rocket geometry, i.e, a cylinder with a leading ogive nose.

I am creating a full 3-d body and the problem is that i am getting a cell at the nose tip of zero volume.

Although i haven't run the case as yet but i have felt its presence while defining the blocks in blockMeshdict file.

Any advice as to how to go about this zero volume cell would be highly helpful.

Thanx


All times are GMT -4. The time now is 18:47.